Philips SHB6110-37 - Manual (Page 9)

E
N
G
L
IS
H
6 Get started
6.1 Charge your headset
Before you use your headset for the first time,
charge the battery for 6 hours for optimum
battery capacity and lifetime.
Warning
Use only the original charger (5V, 500mA). Using
another charger may damage or destroy your
headset.
Plug the charger into the power outlet and
connect the charger cable to the headsets
charging socket.
Caution
Finish your call before charging the headset, as
connecting the headset for charging will cut an
ongoing call.
During recharging the LED indicator will show
a red light. The LED will turn off once charging
is complete. Typically a full charge will take
four hours. You can operate the headset during
charging.
Tip
You can save energy and protect the
environment by unplugging the charger after
charging is complete.
6.2 Pair your headset with your mobile
phone
Your Bluetooth stereo headset must be paired
to your mobile phone before connecting and
using it for the first time with your phone.
“Pairing” will establish a unique encrypted link
between your mobile phone and your headset.
Pairing has to be done
• before using your headset with your mobile
phone for the very first time, or
• after pairing more than two Bluetooth
devices with your headset. Your headset can
store up to two paired devices in its memory,
if you pair more than two devices the oldest
paired device is overwritten.
• “Pairing” is different from “connecting” as
pairing typically only has to be done once,
whereas the phone and headset need to
“connect” every time one of the two devices
was turned off or out of range.