Philips SHB6110-37 - Manual (Page 12)

1
The table below shows how to operate your headset:
In order to: Do this: Sound and LED indicator
feedback
Enter pairing mode Press until the LED starts
blinking red / blue alternately
Alternating red/blue flash
Turn headset on Press for 2 seconds • 3x red flash: battery is low.
• 2x red flash: > 25% of
charge remaining.
• 1x blue flash: > 50% of
charge remaining.
Turn headset off Hold for min. 4 sec One long beep
Play / Pause music Tap
Stop music Tap and simultaneously
Skip Fwd/Bwd Tap or
FullSound on / off Hold and simultaneously
for 4 sec.
One short beep: On
Two short beeps: Off
Adjust volume Tap VOL- or VOL+
Pick up a call / End a call Tap
Pick up a 2 nd call / put other call
on hold / switch back*
Tap
Reject a call Hold One long beep
Redial the last number Double tap Two short beeps
Activate voice dialing* Hold until “beep” sound One short beep
Mute Mic Double tap (during call) Short beep every five
seconds until mute is turned
off.
Transfer call to phone* Hold One short beep
Other status indicators:
Connected to Bluetooth device
(while in standby or while
listening to music)
Blue light flashes every 3 seconds.
Ready for pairing In pairing mode, LED flashes continuously alternating red and
blue.
On but not connected Blue light flashing fast.
In call While call is ringing, blue light flashes fast (twice per second).
After call pick up, slows down to once per second.
Low battery LED will flash red instead of blue. A short double beep will
be heard every minute with five minutes or less of talk time
remaining.
* Available if supported by your mobile phone