Philips MCM590-37B - Manual (Page 10)

10
English
MW
VOLTAGE
NOT FOR ALL VERSIONS
SELECTOR
110V-
127V
220V-
240V
Warning!
– Please note that the voltage selector
located at the rear of this system is
preset at 220V from the factory. For
countries that operate at 110V-127V,
please adjust to 110V-127V before you
switch on the system.
– Use only the supplied speakers.
The combination of the main unit and
speakers provides the best sound.
Using other speakers can damage the
unit and sound quality will be negatively
affected.
– Never make or change connections
with the power switched on.
– Connect the AC power cord to the
power outlet only after you have finished
hooking up everything. – To avoid overheating of the system, a
safety circuit has been built in. Therefore,
your system may switch to Standby
mode automatically under extreme
conditions. If this happens, let the system
cool down before reusing it (not available for
all versions).
Step 1: Connecting FM / MW
antennas
– Place the MW loop antenna on a shelf or
attach it to a stand or wall.
– Extend the FM antenna and fix its ends to the
wall.
– Adjust the position of the antennas for
optimal reception.
– Position the antennas as far as possible from a
TV, VCR or other radiation source to prevent
unwanted noise.
– For better FM stereo reception, connect
external FM antenna.
Connections
Refer to page 3 - P5