Philips DVD624AT99 - Manual (Page 14)

14 Hookups (cont’d)
Connecting to a TV and a Stereo Receiver
(Receiver has Dolby Digital TM or MPEG2)
Back of TV
(example only)
COAXIAL DIGITAL
AUDIO IN
2
1
Stereo Receiver
(example only)
VIDEO IN
VIDEO IN
3
1 Connect either the COAXIAL or OPTICAL jack of the
DVD Player to the corresponding DIGITAL AUDIO IN jack
on your Stereo. You only need one connection. Use an appropri-
ate digital audio cable (not supplied). See your electronics retailer
for details and availability.
2
Connect the supplied video cable to the yellow VIDEO
(VIDEO OUT) jack of the DVD Player and to the TV’s
VIDEO IN jack.
3 Plug the power cords of the DVD Player, Stereo, and the
TV into an active power outlet. Press the POWER ON/OFF
button on the front of the DVD Player to turn on the DVD
Player.
4 Turn on the Stereo power and set your Stereo to the cor-
rect Audio In channel or sound source. Refer to the Stereo
owner’s manual for details.
5 Turn on the TV power. Set the TV to the correct Video In
channel. See your TV owner’s manual for details. Or, change chan-
nels at the TV until you see the DVD screen saver on the TV.
• Set SPDIF OUT accordingly.
Details are on page 38.
• Your Stereo must support
MPEG2 or Dolby Digital TM .
Check the Stereo’s manual.
• If you prefer or need to use the
S-VIDEO or Y C B C R jacks
instead, see pages 11-12.
• A small, square, black cap pro-
tects the OPTICAL jack when it
is not in use. Remove the cap if
you want to use the jack;
replace the cap when the jack
is not in use.
Helpful Hints