Arkon TT136 User Manual

Page 2

Safety Precautions
Do not install Arkon products over an air bag cover or within the air
bag deployment zone. Arkon Resources, Inc. assumes no responsi-
bility of liability for injury or death as a result of car crashes and / or
air bag deployment.

Arkon is not responsible for any damages caused to your car, your
device, or yourself due to the installation or use of this pedestal mount.

The Mobile Mounting Specialists™

Consumer Hotline:
USA (800) 841-0884
INT’L (626) 254-9005
Monday - Friday 9 am - 5 pm, PST

www.arkon.com

Arcadia, CA 91006 USA

Designed in USA | Made in China and Taiwan

Connect the dual T-slots (E) on the back of the adapter plate
to the dual T-tabs (F) on the dash pedestal head.

Step 1.

TomTom EasyPort Device Attachment

Step 1.

While holding the adapter plate, gently insert the device
(not included, sold separately) into the adapter plate until
an audible click is heard.

TomTom EasyPort Adapter Plate Installation

TomTom ONE and ONE XL Device Attachment

Connect the dual T-slots (E) on the back of the adapter plate
to the dual T-tabs (F) on the dash pedestal head.

Removal of Dash Mount

To remove the dash mount completely, use a cotton swab
dipped in isopropyl alcohol. Simply peel up a corner of the
dash mount adhesive and swab under the pad while gently
pulling until the adhesive begins to release. Remove slowly.
No damage will occur from the adhesive if it has been properly
installed and removed per these instructions. You may see a
slight discoloration between this area and other parts of your
dash due to fading caused by the sun.

Step 1.

TomTom GO Series Device Attachment

TT136 | Bendable Adhesive Dash or Console Mount for TomTom® GPS