Bernard SPEC NC-1.1 User Manual

Page 2

1. Install rubber insulator from coupler over the end of neck as shown.

2. Install coupler onto end of neck and torque to approximately 12ft-lbs.

3. After coupler is installed onto neck, slide rubber insulator over to cover

exposed brass on coupler.

4. Install second neck into coupler and tighten by hand or with a wrench.

5. Install snap-on nut cover over locknut for hand tightened necks, or the rubber boot

for wrench tightened necks.

1. Lubricate inner diameter of neck grip with silicone spray, dish soap, or water.

2. Install over neck armor and move to desired position. Neck grip can be used

in place of rubber insulator for wrench tightened necks.

Neck Coupler Installation Instructions

Neck Grip Installation Instructions