Philips DC912-37 - Manual (Page 11)

English
11
Mounting the set onto wall
See the separate sheet of Wall mounting
instructions on how to mount the set onto wall.
Note:
– To secure the mounting on wall, cement wall is
required.
Using Remote Control
IMPORTANT!
– Before using the remote control,
remove the insulation plastic tab as
shown in the picture below.
– If the remote control does not
function correctly or the operating range
is reduced, replace the battery with a
new (CR2025) battery.
1
Push to open the battery tray.
2
Replace a new battery according to the
indicated polarity.
3
Push the battery tray back to close it.
Using the Remote Control to operate
the Player
1
Aim the Remote Control directly at the remote
sensor (IR) on the front panel.
2
Select the source you wish to control by
pressing one of the source select buttons on the
remote.
3
Then select the desired function (for example,
ÉÅ,
¡ or ™).
CAUTION!
– Remove battery if it is exhausted or will
not be used for a long time.
– Battery contains chemical substances, so
they should be disposed of properly.
– Perchlorate Material-special handling
may apply. See www.dtsc.ca.gov/
hazardouswaste/perchlorate.
Preparations
pg001-026_DC912_37_Eng 8/25/08, 10:33 11