Philips WAS5-37 - Manual (Page 16)

English
16
If there is interference in the neighborhood,
the set may pause during playback or
respond slowly to your operation. In such
cases,
– Change the operating channel of your Center
and Station when connecting them to an existing
wireless PC network. To learn about how to change
channels, see the manual Connect to your PC:
Option 2.
– If possible, change the operating channels of the
other Wi-Fi devices at your home.
– Turn the above devices in different directions to
minimize interference.
– Use the WEP* key when connecting your Center
and Station to an existing wireless PC network. See
the Owner’s manual of your router and the manual
Connect to your PC: Option 2.
* stands for Wired Equivalent Privacy. It is a
security protocol for wireless local area
network
Rear connections
Warning:
Never make or change connections with
the mains supply switched on.
Connecting to an audio system
You can easily connect your WAS5 to your
existing home audio systems, such as the audio/
video receiver, home theatre system, mini/micro
system, or multimedia speaker boxes (with built-
in amplifier) and audio amplifiers.
1
Insert the one-plug end of the audio cables
(supplied) to LINE OUT on Station
2
Connect the two-plug end of the audio cables
to the AUX IN (or AUDIO IN) terminals of
the additional appliance, red plug to the to the
red socket AUX IN R and white plug to the
white socket AUX IN L
Installation
LINE OUT
DC
(for illustration only)
3
Select AUX mode on the connected audio
system
Using AC power
1
Make sure all the connections have been made
before switching on the power supply
2
Connect the AC power cord to the wall socket.
This switches on the power supply
When Center or Station is switched to standby,
it is still consuming some power. To disconnect
the system from the power supply
completely, remove the power plug from
the wall socket.
The type plate is located on the rear of the
set.
p001-p025_WAS5_Eng_37 2/8/2006, 10:00 16