Philips Streamium Wireless Music Center&Station WACS57 Center+Station with Wireless streaming - Manual (Page 23)

23
English
If there is interference in the neighborhood,
the set may pause during playback or
respond slowly to your operation. In such
cases
– Use the WEP* key when connecting your Center
and Station to an existing wireless PC network. See
the Owner’s manual of your router and the manual
Connect to your PC: Option 2.
– Change the operating channel of your Center
and Station when connecting them to an existing
wireless PC network. To learn about how to change
channels, see the manual Connect to your PC:
Option 2.
– If possible, change the operating channels of the
other Wi-Fi devices at your home.
– Turn the above devices in different directions to
minimize interference.
* stands for Wired Equivalent Privacy. It is a
security protocol for wireless local area
network
Rear connections
Warning:
Never make or change connections with
the mains supply switched on.
On Center
A
Connecting to an audio system
You can easily connect your WAC5 to your
existing home audio systems, such as the audio/
video receiver, home theatre system, mini/micro
system, or multimedia speaker boxes (with built-
in amplifier) and audio amplifiers.
Using audio cables, connect one (one set) of
WAC5’s sound output terminals: LINE OUT,
DIGITAL OUT
or OPTICAL OUT to the
corresponding input terminals in the connected
device.
Helpful hints:
– For better sound output, use DIGITAL OUT or
OPTICAL OUT if it is available on the connected
device.
LINE OUT:
1
Insert the red plug of the red/white audio
cables (supplied) to the red socket LINE
OUT R
and the white plug to the white
socket LINE OUT L
2
Connect the other end of the audio cables to
the AUX IN (or AUDIO IN) terminals of
the additional appliance, red plug to the red
socket AUX IN R and white plug to the
white socket AUX IN L
OPTICAL OUT
DIGITAL OUT
3
Select AUX mode in the connected audio
system
DIGITAL OUT:
1
Insert the plug of digital audio cables (not
supplied) to the DIGITAL OUT socket
2
Connect the other end of the audio cables to
the DIGITAL IN terminal of an additional
appliance
Installation
(for illustration only)
OPTICAL OUT
DIGITAL OUT
3
Select the Digital Input mode (such as DI) in the
connected audio system
Helpful hints:
– Noises occur if the digital output/input does not
suit your audio system’s amplifiers well. In that case,
use the LINE OUT /AUX IN connection instead.
See the steps under LINE OUT.
– Always refer to the owner’s manual of other
equipment for details.
Center
p001-P052-WACS57_Eng_37 1/25/2006, 14:12 23