Philips docking speaker with Bluetooth® DS3600 for iPod-iPhone-iPad - Manual (Page 11)

11 EN
5 Product
information
Note
• Product information is subject to change without prior
notice.
Specifications
Amplifier
Rated Output Power 2 X 10 W RMS
Signal to Noise Ratio > 57 dBA
Aux-in Link 500mV RMS
Bluetooth
Standard Bluetooth Standard
Version 2.1+EDR
Output power 0 dBm (Class 2)
Frequency band 2.402~2.480 GHzISM
Band
Range 10m (free space)
General information
AC Power Model: AS300-120-
AA250 (Philips);
Input: 100-240 V ~,
50/60Hz, 1.1A;
Output: 12 V 2 5 A
Operation Power
Consumption 15 W
Standby Power
Consumption <0 5 W
Max. load for iPod/
iPhone/iPad 5 V 2.1 A
Dimensions
- Main Unit
(W x H x D) 285 x 136 x 143 mm
Weight
- Main Unit
- With Packing
1 2 kg
2.0 kg
6 Troubleshooting
Warning
• Never remove the casing of this device.
To keep the warranty valid, never try to repair
the system yourself.
If you encounter problems when using this
device, check the following points before
requesting service. If the problem remains
unsolved, go to the Philips Web page
(www.philips.com/support). When you contact
Philips, make sure that the device is nearby
and the model number and serial number are
available.
No power
• Ensure that the AC power adaptor of the
unit is connected properly.
• Ensure that there is power at the AC
outlet.
No sound or poor sound
• Adjust the volume of your docking speaker.
• Adjust the volume of your iPod/iPhone/
iPad, Bluetooth devices or other external
devices.
No response from the unit
• Disconnect and reconnect the AC power
adaptor, then turn on the unit again.
Cannot sync with PC
• Switch the docking speaker to standby
mode.
• Try another USB cable.
• Install iTunes in PC properly.