Philips MCM704D-37 - Manual (Page 27)

English
27
Clock/Timer
Setting the clock
1
In Standby mode, press and hold CLOCK on
the remote until the time flashes on the display.
➜
”
SET CLOCK” is displayed briefly. Then, the
hour digits flash on the display screen.
2
Turn VOLUME -/+ clockwise or anticlockwise
or press VOL +/- on the remote to set the
hours.
3
Press CLOCK to confirm.
➜
The minute digits flash on the display screen.
4
Turn VOLUME -/+ clockwise or anticlockwise
or press VOL +/- on the remote to set the
minutes.
5
Press CLOCK again to confirm the clock
setting.
Notes:
– This system only supports 12-hour mode.
– The clock setting will be erased when the system
is disconnected from the power supply.
– The system will exit clock setting mode if no
button is pressed within 30 seconds.
Viewing the clock
●
Press CLOCK in the active mode.
➜
The clock time is displayed.
Setting the timer
●
The system can be used as an alarm clock,
whereby the CD, USB, TUNER, AUX is switched
on at a set time. The clock time needs to be set
first before the timer can be used.
●
During setting, if no button is pressed within 30
seconds, the system will exit timer setting mode
automatically.
1
Press and hold SLEEP/TIMER on the remote
control until the time flashes on the display.
➜ ” SET TIMER” is displayed briefly. Then, the
hour digits flash on the display screen.
2
Turn VOLUME -/+ clockwise or anticlockwise
or press VOL +/- on the remote to set the
hours.
3
Press SLEEP/TIMER to confirm.
➜
The minute digits flash on the display screen.
4
Turn VOLUME -/+ clockwise or anticlockwise
or press VOL +/- on the remote to set the
minutes.
5
Press SLEEP/TIMER to confirm the time
setting.
➜
”
OFF” flashes on the display screen.
6
Turn VOLUME -/+ clockwise or anticlockwise
or press VOL +/- on the remote to select
“ON”.
➜
icon appears on the display screen.
To deactivate the timer
● Select “OFF” at Step 6.
Activating and deactivating
SLEEP
The sleep timer enables the system to switch off
by itself after a set period of time.
● Press SLEEP/TIMER on the remote control.
➜
The display shows one of the sleep time
options in the following sequence: SLEEP-OFF,
SLEEP-10, SLEEP-20, ... SLEEP-90,
SLEEP-OFF ... Once the sleep funtion is
activated, the
SLEEP icon will be displayed.
●
To deactivate, press SLEEP/TIMER on the
remote control once or more until OFF is
shown, or press STANDBY-ON/ ECO
POWER B (or B on the remote).
➜ SLEEP disappears.
pg001-031_MCM704D_37-Eng 2007.4.7, 14:51 27