Philips MCM704D-37 - Manual (Page 11)

English
11
Preparations
Rear connections
The type plate is located at the rear of the
system.
A Power
Before connecting the AC power cord to the
wall outlet, ensure that all other connections
have been made.
Warning!
– For optimal performance, use only the
original power cable.
– Never make or change any connections
with the power switched on.
To avoid overheating of the system, a safety
circuit has been built in. Therefore, your
system may switch to Standby mode
automatically under extreme conditions. If
this happens, let the system cool down
before reusing it
(not available for all versions).
B Connecting the control cable
Connect the serial port marked “CONTROL
CABLE” at the rear of the CD player to the
same port at the rear of the power amplifier
with the supplied flat control cable.
C Connecting antennas
Connect the supplied AM antenna and FM
antenna to the respective terminals. Adjust the
position of the antenna for optimal reception.
AM Indoor Antenna
1
2
●
Position the antenna as far as possible from a TV,
VCR or other radiation source.
Speaker
(right)
Speaker
(left) FM antenna
AC power cord
AM antenna
pg001-031_MCM704D_37-Eng 2007.4.7, 14:50 11