Philips BDP7200-F7E - Manual (Page 15)

15 EN
Pla
yback
F
unc
tion S
etup
O
thers
In
tr
oduc
tion
C
onnec
tions
Basic S
etup
Press [OUTPUT] on the front panel to change the resolution of the video signal being output from the HDMI OUT. The
video resolution changes as follows every time [OUTPUT] is pressed. Or change the setting in the “HDMI Video
Resolution” in the settings menu.
Front Panel Display HDMI Video Resolution
480 Progressive
Press [OUTPUT]
720 Progressive
Press [OUTPUT]
1080 interlaced
Press [OUTPUT]
1080 Progressive
Press [OUTPUT]
Copyright protection system
To play back the digital video images of a BD-video or DVD-video via an HDMI connection, it is necessary that both
the player and the display device (or an AV receiver / amplifier) support a copyright protection system called HDCP
(high-bandwidth digital content protection system). HDCP is copy protection technology that comprises data
encryption and authentication of the connected AV device. This unit supports HDCP. Please read the operating
instructions of your display device (or AV receiver / amplifier) for more information.
HDMI: High Definition Multimedia Interface
Note
When using HDCP-incompatible display device, the picture will not be viewed properly.
The audio signals from the HDMI jack (including the sampling frequency, the number of channels and bit length)
maybe limited by the device that is connected.
Among the display device(s) that support HDMI, some do not support audio output (for example, projectors). In
connections with device such as this unit, audio signals are not output from the HDMI output jack.
When this unit’s HDMI jack is connected to a DVI-D compatible display device(s) (HDCP compatible) with an HDMI-
DVI converter cable, the signals are output in digital RGB.
Pressing [OUTPUT] does not work when HDMI cable is not connected, or when no video signal is being output
from the HDMI OUT jack.
Pressing [OUTPUT] does not work during the playback of a BD-video or while displaying the settings menu.
When you make a selection, the TV monitor temporarily goes blank and then comes back again. If it does not,
press [OUTPUT] repeatedly to change the resolution or press and hold [B (PLAY)] on the front panel for 5 seconds
to change the setting back to its default. •
•
•
•
•
•
•
*
CONNECTIONS
HDMI Mode and Actual Output Signals
E5H11UD-BDP7200_EN_v2.indd 15 E5H11UD-BDP7200_EN_v2.indd 15 2008/09/18 13:55:11 2008/09/18 13:55:11