Philips DVDR3576H-37B - Manual (Page 21)

21 EN
Recording
Playback
Editing
Introduction
Connections
Basic Setup
Function Setup
Others
21 EN
BEFORE YOU START
After you have completed all the connections, you must find the viewing channel (external input channel) on your TV.
1 After you have made all the
necessary connections, press
[STANDBY-ON y
y ] to turn on the unit.
2 Turn on your TV.
• If connected to your VCR make sure it is
switched off or in standby mode before
proceeding.
3 Press “2” on the TV’s remote control,
then press channel down button
repeatedly until you see “Initial
Setup” menu.
Initial Setup
OSD Language
English
Français
Español
This is the correct viewing channel (external
input channel) for the recorder.
• For some TVs, there may be a button on the
TV’s remote control that accesses the external
input channel. It may be labeled “SOURCE”,
“AV”, or “SELECT”. In such case, press it
repeatedly. Refer to your TV’s user manual for
details.
• If more than 10 minutes have past since you
have turned on the unit, you may see the
PHILIPS screen saver instead of “Initial Setup”
menu.
PHILIPS screen saver:
4 Proceed to step 2 in “INITIAL
SETTING” on page 26.
Finding the Viewing Channel on Your TV
Note
• Video input selection varies for different brand’s
models of TVs.
• Consult your TV manufacturer if none of the above is
successful.
HDD & DVD RECORDER
E2H42UD_DVDR3576H-37_EN.indd 21 E2H42UD_DVDR3576H-37_EN.indd 21 2007/12/28 11:14:51 2007/12/28 11:14:51