Philips DVDR3576H-37B - Manual (Page 115)

115 EN
Recording
Playback
Editing
Introduction
Connections
Basic Setup
Function Setup
Others
115 EN
TROUBLESHOOTING
GENERAL
Certain functions of the DVC cannot
operate. • Some functions may not operate depending on the type of DVC. For
example, if the DVC does not support slow playback mode, the slow
playback function is disabled.
• With E3(DV-IN), the disc display menu does not appear unless disc
playback is executed.
DV audio signal cannot be switched. • For recording with the DVC, the recording audio signal can be set to 12
bits or 16 bits. However, when 16-bit recording mode is selected, audio
signal cannot be switched. To record an audio signal, set it to 12 bits.
No image from HDMI connection. • Check the HDMI connection. (Check the status of the HDMI related
indications.)
• Check whether the connected monitor device or other device supports
HDCP. (This unit will not output a video signal unless the other device
supports HDCP.)
• Check the setting of HDMI.
• Check whether the output format of this unit (HDMI FORMAT) matches
the supported input format of other connected device.
CHANNEL
TV channels cannot be changed. • Check if the connections are made securely and correctly.
• Check if the cables are damaged.
• Try channel setting by following the steps on pages 27 to 29.
Only specific channels do not appear. • The channels may be set to be skipped. (Refer to pages 28-29.)
The external input channels (such as
E1, E2 or E3) cannot be skipped. • This unit does not skip the external input channels. This is not a
malfunction.
RECORDING
GENER
AL The image from the external device
cannot be displayed or recorded.
• Try pressing [SOURCE / USB] repeatedly.
• Turn on all connected devices.
• Check if the connections are made securely and correctly.
HDD / DVD
Recording is impossible. • It is prohibited to make a recording from 2 minutes before the
programmed start time of a timer recording.
• This unit cannot record programs that contain copy protection signal.
This is not a malfunction.
• The space of the recording media may be used up. Try deleting
unnecessary titles, or exchange it with the recordable media.
• The maximum number of titles or chapters has exceeded. Delete the
unnecessary titles to make enough space or insert a new recordable media.
• Check if the connections are made securely and correctly.
• Check the external input channel. In USB mode, you cannot make a
recording on HDD/DVD.
Timer recording cannot be
performed. • The internal clock of the unit may have been stopped due to a power
failure that lasted for more than 30 seconds. Reset the clock. (Refer to
pages 30 to 31.)
HDD
Titles which were supposed to be
recorded by the pause live TV
function cannot be found in the
title list. • Titles recorded by the pause live TV function will not be stored in the title
list. They may be stored temporarily in the title list, but will be deleted
when you exit the pause live TV mode. Pause live TV mode will stop not
only when you press
[STOP C] twice, but also when the disc runs out of
space, when the recording time exceeds 12 hours, or when it comes to 2
minutes before timer recording. This is not a malfunction.
DVD
Recording is impossible. • Copy-once programs cannot be recorded on DVD. This is not a
malfunction.
• Check if the disc is protected or fi nalised. Undo the protection or the
fi nalisation.
• DVD-RW once formatted on other unit cannot be recorded on this unit
unless all the contents in the disc are erased.
• Check if the connections are made securely and correctly.
The indication
“
Writing to Disc 100%
”
does not disappear.
• “
Writing to Disc 100%
” may remain on screen for the
maximum of 20 seconds even after it reached 100%. This is not a
malfunction.
E2H42UD_DVDR3576H-37_EN.indd 115 E2H42UD_DVDR3576H-37_EN.indd 115 2007/12/28 11:16:33 2007/12/28 11:16:33