Philips Mini Hi-Fi System NTRX500 650W Bluetooth - Manual (Page 19)

17 EN
7 Listen to radio
Tune to a radio station
Tip
•
Keep the unit away from other electronic devices to
avoid radio interference.
• For better reception, fully extend and adjust the
position of the antenna.
1
Slide CROSS FADER to the far left.
2
Press TUNER on the remote control, or
(Left) on the main unit repeatedly to select
FM or AM tuner.
3
Press and hold or for 2 seconds.
» [SEARCH] (search) is displayed.
» The radio tunes to a station with
strong signal automatically .
4
Repeat step 3 to tune to more stations.
• To tune to a station manually, press
or repeatedly until you find optimal
reception.
Program radio stations
automatically
Note
•
You can program a maximum of 30 FM and 10 AM
radio stations.
In tuner mode, press and hold PROG for 2
seconds to activate automatic program mode.
» [AUTO] (auto) is displayed.
» The unit stores radio stations with
sufficient signal strength automatically.
» After all available radio stations are
stored, the first stored radio station is
broadcast automatically.
Program radio stations
manually
1
Tune to a radio station.
2
Press PROG to activate the program
mode.
» A position number is displayed.
3
Press ALB/PRESET+/- to allocate a
number to this radio station, then press
PROG to confirm.
4
Repeat steps 1-3 to program other
stations.
Tip
•
To overwrite a programmed station, store another
station in its place.
Select a preset radio station
In tuner mode, press ALB/PRESET+/- to select
a preset number.
Change AM tuning grid
In some countries, the AM radio frequency step
between adjacent channels is 10 kHz or 9 kHz.
• In AM tuner mode, press and hold for 5
seconds.
» The frequency step is changed to 9
kHz or 10 kHz.
» All preset stations are erased and re-
programmed in AM mode.