Philips HF3480-01 - Manual (Page 10)

Problem Solution
Perhaps there was a power failure that lasted more than approximately
15 minutes. In this case the appliance has remembered all settings
except the clock time. The clock time therefore flashes on the display.
Set the correct clock time.
The alarm did not go off
9 minutes after I pushed
the control lever down
to snooze.
Perhaps you pushed the control lever down with so much force that it
jumped to off position.
Perhaps you set the volume level to 0 (shown on the display as ‘OFF’).
The light wakes me too
early.
Perhaps the light intensity level you have set is not appropriate for you.
Try a lower light intensity level if you wake up too early. If light intensity
1 is not low enough, move the appliance further away from the bed.
The light wakes me too
late.
Perhaps the appliance is positioned at a lower level than your head.
Make sure the appliance is located at a height at which the light is not
blocked by your bed, comforter/blanket or pillow. Also make sure the
appliance is not placed too far away.
The lamp flashes. Perhaps there has been a power failure. It is normal for the lamp to
flash after a power failure.
Perhaps the appliance is not suitable for the voltage to which it is
connected. Make sure that the voltage indicated on the appliance
corresponds to the local voltage.
EnglisH 16