Philips Clock Radio AJ3600 User Manual
Page 13
ALARM 2 to confirm the setting.
Helpful hints:
– If you have selected AL 1 (AL
), make sure you have properly tuned to a
station before turning off the set.
– If you set and activate the same time for both alarms, only the AL 2 (AL
)
will be activate at the set time.
– When both AL 1 (AL
) and AL 2 (AL
) are turned on, by default the
display
shows the alarm time nearest to activation.
– To check the alarm time setting for AL 1 or AL 2, press AL 1 or AL 2 button.
– It is not possible to adjust the alarm time during an alarm call or the repeat
alarm mode.
SWITCHING OFF THE ALARM
There are three ways of switching off the alarm. Unless you cancel the
alarm completely, the 24-hour ALARM RESET will be automatically
selected after 59 minutes from the time your alarm first goes off.
24 HOUR ALARM RESET
If you want the alarm mode to be stopped immediately but also wish to
retain the same alarm setting for the following day:
• Press ALARM RESET / SLEEP.
™ You will hear a beep tone confirming 24 hour reset activation.
REPEAT ALARM
This repeats your alarm call at 9 minute intervals.
• During the alarm call, press REPEAT ALARM /
BRIGHTNESS
CONTROL
..
™ Display shows (
AL
) or (
AL
) flashing during a repeat alarm.
• Repeat if desired
(up to a
maximum of 6 times).
CANCELING THE ALARM COMPLETELY
• Press AL 1 or AL 2 button once or more until the OFF appears
under the respective (AL
) or (AL
) icon.