Philips Clock Radio AJ3600 User Manual

Page 12

To improve reception:
For FM, extend and position the pigtail fully to obtain optimum reception.
For AM, the set is provided with a built-in aerial. Direct the aerial by adjusting
the position of your clock radio.

STORING AND USING PRESET STATIONS

You can store up to a total of 10 radio stations in the memory, 5 on each
waveband.
1 Tune to your desired station (see TUNING TO RADIO STATIONS).
2 To store a preset, hold down briefly on a PRESET button 1-5 until you hear a

double beep.

™ Display shows the preset number of your station.
3 Repeat steps 1 and 2 to store your other stations.
• You can overwrite a preset station by storing another frequency in its place.
4 Press a.PRESET button 1-5 to listen to a preset station.

USING THE ALARM

GENERAL
Two different alarm times can be set. This can be useful when you need to
be woken up at a different time e.g. during the week and at the weekend:
• ALARM 1 - radio mode
• ALARM 2 - buzzer mode. The gentle wake buzzer alarm increases its beep

tone frequency within seconds.

SETTING THE ALARM TIME AND MODE (See

1. Check the radio is switched off.
2. Press AL 1 or AL2 to on.

™ Display: ON appears under the respective

icon.

3. Press and hold SET ALARM 1 or SET ALARM 2 until alarm time

digits flash.

4. Hold down or press HOUR + or MINUTE + repeatedly to set and

adjust the hours and minutes respectively. Release HOUR + or
MINUTE + when you have reached the correct setting.

5. After both the hours and minutes are set, press SET ALARM 1 or SET