Philips MCD288-37 - Manual (Page 39)

English
39
Clock/Timer
Clock setting
See "Preparations-Step 2: Setting the clock".
Timer setting
● The system can be used as an alarm clock,
whereby the last selected source is switched on
at a set time (one time operation). The clock
time needs to be set first before the timer can
be used.
1
In standby mode, press and hold SLEEP/
TIMER for more than three seconds.
➜ " TIMER SET" is displayed briefly. Then, the
hour digits flash on the display panel.
2
Press VOLUME -/+ (VOL +/- on the remote)
to set the hours and SLEEP/TIMER to
confirm.
➜
The minute digits flash on the display panel.
3
Press VOLUME -/+ (VOL +/- on the remote)
to set the minutes and SLEEP/TIMER to
confirm.
➜ " TUN", “DVD” or "USB" flashes.
4
Press VOLUME -/+ (VOL +/- on the remote)
to select your desired source.
5
Press SLEEP/TIMER to complete the setting.
➜
Display shows .
To deactivate the timer
●
Press SLEEP/TIMER again.
➜
disappears.
Sleep timer setting
The sleep timer enables the system to switch off
by itself after a set period of time.
1
Press SLEEP/TIMER on the remote control
repeatedly to select a preset time.
➜
The selections are as follows (time in
minutes):
OFF ™ 15 ™ 30 ™ 45 ™ 60 ™ 75 ™ 90 ™
105 ™ 120 ™ OFF
➜
"
SLEEP XX" or "SLEEP OFF" is displayed.
"
XX" is the time in minutes.
2
When you reach the desired length of time, stop
pressing SLEEP/TIMER.
➜ Display shows .
To deactivate the sleep timer
● Press SLEEP/TIMER repeatedly until " 00" is
displayed, or press STANDBY-ON y
(STANDBY y on the remote).
➜ disappears.
pg026-pg045_MCD288-37-Eng-B 2006.3.15, 16:01 39