Broilmaster P4-1 - Manual (Page 16)

Page 16 B101227-3-0408
Connecting to Propane Gas / Cylinder Retention Means
ATTENTION: Propane gas cylinders that are acceptable for use with this grill must comply with Cylinder Requirements, Page 14,
and Connection Requirements, Page 15.
Position the cylinder in the opening in the bottom of the cart and secure with the cylinder retaining bracket. See Figure 11.
The pressure regulator has an outlet pressure of not more than eleven (11") inches water column. It must be connected to the Propane
gas cylinder’s female valve outlet before the grill can be operated.
Caution: Operation of a Propane gas grill without the pressure regulator and hose assembly will cause gas leaks which could
lead to fire or explosion, resulting in property damage or personal injury.
The pressure regulator’s fitting must remain clean and free of nicks and scratches. A dirty, nicked or scratched fitting can cause a gas leak,
resulting in an explosion or fire. Use only genuine Broilmaster ® replacement parts unless otherwise specified by the manufacturer.
Pressure Regulator and Hose Assembly
Cylinder
Retaining
Bracket
Attach the pressure regulator to the Propane gas cylinder’s valve
using the plastic handwheel. Tighten in a clockwise motion to
achieve a gas tight seal. See Figure 12.
Caution: Do not use a wrench or any other tool to tighten. Use
of a wrench or other tool will damage the plastic handwheel.
To disconnect the Propane gas cylinder, turn OFF the cylinder’s
valve and the grill’s control valve. Remove the regulator by turning
the plastic handwheel counterclockwise.
Clockwise
Clockwise
Figure 12
Figure 11
PROPANE GAS GRILLS