Ignitor assembly, Installing the ignitor, Grill assembly – Broilmaster P4-1 User Manual

Page 10

Page 10

B101227-3-0408

Ignitor Assembly

Slide the collector box spacer (26) and nut (provided on assembly)

onto the collector box shaft and tighten. See Figure 1.

Note: Peel protective ﬁlm from control panel label before

installing ignitor.

Installing the Ignitor

Caution: Do not cut or damage ignitor wire.

Carefully thread the end of the ignitor wire through the center hole

in the grill bottom. Slide the ground lug (25) over the ignitor wire

and fasten with nut provided.

Attach one end of the ground wire (24) to the terminal on the rear

of the electronic ignitor. Attach the remaining end to the ground

lug. See Figures 1 and 2.

Attach ignitor wire to the spark terminal on the rear of the elec-

tronic ignitor.

Nut

�

Figure 1

Figure 2

GRILL ASSEMBLY