Bakers Pride GO-36 - Manual (Page 9)

Gourmet Oven Installation
7
Installation
Serious injury, equipment damage or death could result if attempting to install this
oven. Ensure that an authorized BKI service agent install the oven.
Unpacking and Handling
It is the owners’ responsibility to file all freight claims with the delivering truck line. Inspect all cartons and
crates for damage as soon as they arrive. If damage to cartons or crates is found, or if a shortage is
found, note this on the bill of lading (all copies) prior to signing.
If damage is found when the equipment is opened, immediately call the delivering truck line and follow up
the call with a written report indicating concealed damage to your shipment. Ask for an immediate
inspection of your concealed damage item. Packaging material MUST be retained to show the inspector
from the truck line.
Remove all packing from the interior and exterior of the oven.
GO-36 Stacking Instructions
Tools Required: 7/16 combination wrench
7/16 socket and ratchet
(2) 2x4x30” pieces of wood
NOTE: Remove all plastic from stacking kit parts.
1. Remove racks and drip pans from inside both ovens.
2. Place two wood 2x4x30” pieces on the floor. Tilt unit back onto wood pieces being careful not to
crush fuse holders or power cord.
3. Remove casters and place large aluminum base WB56210600 (lip goes downward) between the
bottom of the oven and the casters. Install the caster hardware that was removed.
4. Carefully place unit upright.
5. Remove the heater control unit of the base unit (3 screws on each side). Place four (4) small
stainless steel angles (FA56210702) at the outside corners of the gasket on the oven cabinet.
Replace heater control unit.
6. Carefully place second unit on its back just as in step 2.
7. Remove casters and store. Place stacking kit piece AB56210500 (with louvers on sides) with
notches toward the oven back. Install hardware removed from the casters to secure the stacking
kit piece to the oven bottom. Install four (4) handles on sides of stacking kit piece using
1/4-20 x 1” bolts and lockwashers.
NOTE: Be sure handles are secure.
8. Place unit upright.
NOTE: Lock the casters on the bottom unit.
Be careful not to pinch hands while installing the top unit.