Philips 740815008 - Manual (Page 36)

PROBLEMS CAUSES REMEDIES
The machine does not
turn on.
The machine is not
connected to the power
supply.
Move the main switch to ON.
Check the plug and the
connection
The coffee is not hot
enough.
The cups are cold. Warm up the cups.
A low temperature has
been set.
Set the machine on a higher
temperature.
Only water is
dispensed when you
select “preground
coffee”.
No preground coffee has
been introduced.
Dispense again after
introducing preground coffee.
No hot water or steam
is dispensed.
The tube nozzle is
clogged.
Clean the nozzle opening
with a needle.
During this ope-
ration, the knob must
be closed and the machine
must be off.
The machine takes a
long time to warm up.
Excessive scale has
built up.
Descale the machine.
The brew unit cannot
be removed.
The unit has stopped in
the wrong position.
Close the door and switch on
the machine; the brew unit
will move back into position.
Messages are displayed to guide users and help them to use the machine correctly.
Press “MENU/OK”
Descale the machine
Fill the water tank with fresh drinking water.
Fill the coffee bean container and start the coffee
dispensing cycle.
Open the door, remove the dregs drawer and empty the
used coffee grinds into a suitable container.
Important note: the dregs drawer may be emptied only when the machine
is on. The drawer must be removed for at least 5 seconds. If you empty the
drawer with the machine off, you will not be able to dispense coffee the next
time you switch the machine on.
Fit the brew unit properly in place.
Fit the drip tray and dregs drawer properly in place.
Close the front door.
Load the circuit (Starting up)
Contact an authorised service centre.
DISPLAY MESSAGES
ENERGY SAVING
FILL WATERTANK
COFFEE BEANS EMPTY
DREGDRAWER FULL
BREWUNIT MISSING
DREGDRAWER MISSING
BREWUNIT BLOCKED
GRINDER BLOCKED
CLOSE DOOR
DESCALING
READY FOR USE
36
VENTILATE