Philips MCD735-37B - Manual (Page 36)

36
English
Radio Reception
Tuning to radio stations
1
Press ECO POWER/STANDBY-ON y (or y
on the remote) to switch on the last selected
source.
2
Press SOURCE (or TUNER on the remote)
to select TUNER mode.
3
Press BAND/
9 (or TUNER on the remote)
again to select the desired band: FM or AM.
4
Press and hold the control knob to the left/right
(corresponding to
S / T ) or TU +/- а /
б on the remote until the frequency indication
starts to change, then release.
➜ The system automatically tunes to the next
strong radio station.
● To tune to a weak station, press the control
knob to the left/right (corresponding to
S /
T ) or TU +/- а / б on the remote
briefly and repeatedly until an optimal reception
is found.
5
Repeat Step 4 if necessary until you find the
desired radio station.
Presetting radio stations
You can preset up to 40 stations (20 in each
band) regardless of the reception.
1
Tune to your desired radio station (refer to
“Tuning to radio stations”).
2
Press the control knob upward (corresponding
to PROGRAM) or press PROG on the
remote.
➜
”
PROG” icon flashes.
3
Press CH +/- ( ¡ / ™) on the remote to select
the desired preset number.
➜ If “ PROG” icon goes off before you select the
desired preset number, press the control knob
upward (corresponding to
PROGRAM) or press
PROG on the remote.
4
Press the control knob upward (corresponding
to PROGRAM) or press PROG on the
remote again to store the radio station.
● Repeat steps 1-4 to store other radio stations.
Other Functions
Listening to preset radio stations
● In tuner mode, press PRESET/ ÉÅ (or CH +/
- ( ¡ / ™) on the remote) to select the desired
preset number.
➜ The preset number, radio frequency, and
waveband are displayed.
Setting the clock
1
In Standby mode, press and hold CLOCK on
the remote until the time flashes on the display.
➜ ” CLOCK SET” is displayed briefly. Then, the
hour digits flash on the display screen.
2
Turn VOLUME -/+ clockwise or anticlockwise
or press VOLUME +/- on the remote to set
the hours.
3
Press CLOCK to confirm.
➜ The minute digits flash on the display screen.
4
Turn VOLUME -/+ clockwise or anticlockwise
or press VOLUME +/- on the remote to set
the minutes.
5
Press CLOCK again to confirm the clock
setting.
Notes:
– This system only supports 12-hour mode.
– The clock setting will be erased when the system
is disconnected from the power supply.
– The system will exit clock setting mode if no
button is pressed within 30 seconds.
pg001-043_MCD735_37_Eng 2006.7.20, 15:14 36