Philips MCD735-37B - Manual (Page 10)

10
English
Connections
IMPORTANT!
– The type plate is located at the
bottom of the system.
– Before connecting the AC power cord
to the wall outlet, ensure that all
other connections have been made.
– Never make or change any
connections with the power switched on.
Step 1: Placing the speakers and
subwoofer
1
3 3
1
4
2
Center speaker and
DVD system
Surround
Subwoofer
Speaker (Left)
Surround
Speaker (Right)
Front speaker with
stand (Left)
Front speaker with
stand (Right)
For best possible surround sound, all the
speakers (except subwoofer) should be placed
at the same distance from the listening position.
1
Place the front left and right speakers at equal
distances from the TV and at an angle of
approximately 45 degrees from the listening
position.
2
Place the center speaker above the TV or the
DVD system so that the center channel's sound
is localized.
3
Place the rear speakers at normal listening ear
level facing each other or hang on the wall.
4
Place the subwoofer on the floor near the TV.
Notes:
– To avoid magnetic interference, do not position
the front speakers too close to your TV.
– Allow adequate ventilation around the DVD
system.
Step 2: Connecting speakers
and subwoofer
1
Connect the supplied front, rear and center
speakers using the fixed speaker cables by
matching the colors of the jacks and speaker
cable connectors.
2
Connect the passive subwoofer to the
WOOFER (4
Ω) terminal with the supplied
subwoofer cable by matching the plug types.
Note:
– Ensure that the speaker cables are correctly
connected. Improper connections may damage the
system due to short-circuit.
Step 3: Connecting the control
cable
Connect the serial port marked “CONTROL
CABLE” at the rear of the DVD player to the
same port at the rear of the power amplifier
with the supplied flat control cable.
pg001-043_MCD735_37_Eng 2006.7.20, 15:13 10