How to use – Black & Decker CM1010B User Manual

Page 4

4. Close the filter holder tightly until it snaps into

place (F).

5. Place filter holder inside the water reservoir and

insert it into the recess at the bottom right hand

corner (G).

Note: Replace carbon filter every 60 brewing cycles

or every 2 months after removing it from the sealed

package. (Call the 800 number on the front cover

for replacements.)

ADJuSTING POWER CORD LENGTH
Tip: You can adjust length of power cord to suit your needs.
1. To increase length of power cord, simply grasp cord (not plug) in rear of

coffeemaker and gently pull down and out of slot away from coffeemaker.

2. To decrease length of power cord, simply feed any excess cord into slot in

rear of coffeemaker.

SETTING THE CLOCK

1. Plug appliance into standard electrical outlet.
2. digital clock display flashes 12:00 (H).
Note: You must set display clock in order to use

delayed Brewing feature.

3. To change time, press HoUR button until correct

time appears (J).

Note: When the time passes noon, a small icon

appears in the top left corner of the digital display

to let you know you are in PM time. If PM indicator

is not illuminated, the time is AM.

4. Repeat with MINUTe (MIN) button (K).
Tip: Hold buttons down to make hours and minutes

change rapidly after a short delay. To change the

time in 1-digit increments, press and release the

buttons.
Note: If coffeemaker is unplugged or power is

interrupted even momentarily, display time may

need to be reset.

How to use

This product is for household use only.
GETTING STARTED
• Remove all packing material and any stickers from product.
• Remove and save literature.
• Please go to www.prodprotect.com/applica to register your warranty.
• Wash all removable parts as instructed in CARe ANd CleANING section of

this manual.

• open one-piece cover and insert permanent nylon mesh

filter or empty paper filter into removable filter basket

(C).

• Pour fresh cold water up to 12-cup (MAX) mark into the

water reservoir (D).

• Close one-piece cover.
• Place empty carafe on "Keep Hot" carafe plate.
• Pull power cord out from power cord holder in back of

coffeemaker and plug into standard electrical outlet.

• Brew water through appliance following BReWING CoFFee instructions,

without adding coffee grounds.

Note: This removes any dust or residue that may remain in system during

manufacturing process.
• discard water from carafe and paper filter, if used, from filter basket.
• Turn off coffeemaker, unplug and allow to cool down.
WATER FILTER
1. Remove carbon filter from packing material.

2. Press latch on filter holder to open (E).
3. Place carbon filter inside.

ENGLISH