Assembly – Philips SDV7700K-17 User Manual

Page 8

Text mode
Original mode

Assembly

Lead-In Wire

• Attach lead-in wire to house with screw-type standoffs.
• Tighten standoffs with pliers after wire is installed.
• Avoid sharp bends in lead-in wire.
• Form drip loop where wire enters wall.
• Wall mounts not included.
• Mounts, mast and standoffs are not included.

Band Separator

• Attach band separator to appropriate terminals on TV set.
• Attach antenna lead-in wire to band separator.
• An FM set or second TV set may be attached to second output

of band separator.

NOTE: Band separator is only required for older TV sets with sep-

arate VHF/UHF inputs. For most newer sets, simply connect cable
from antenna to ‘F’ input.