Philips SDV7700K-17 - Manual (Page 6)

6
EN
Assembly
• Insert UHF Boom-A into UHF Boom-B and secure using
1-1/2˝ screw and lock washer.
• Attach Reflector Arm Mounting Brackets to assembled UHF
Boom (previous step) using two 1-1/2˝ screws and wing-nuts.
Ensure that rotation arcs in Reflector Arm Mounting Brackets
face toward UHF Boom elements.
• Attach Corner Reflector Arms to Reflector Arm Mounting
Brackets by sliding Reflector Arms between Mounting
Brackets. Secure with 1-1/2˝ screw and wing-nuts. To fully
secure Reflector Arms, snap into locking tabs and tighten
screws.
Assembly of VHF Portion
• Rotate reflector element rods on VHF Boom-A and VHF
Boom-B into place. NOTE: When rotating element rods,
grasp close to pivot and relieve spring pressure on pivot
bracket detents. Don’t apply excess pressure to reflector ele-
ment rods.
• Attach one 46˝ Element to hole A in VHF Boom-B.
• Attach one 50˝ Element to VHF Boom-B.
Repeat each steps with second boom for VHF Boom-B.