Philips SDV7700K-17 - Manual (Page 5)

5
EN
P a rts included:
a. UHF Boom-A . . . . . . . . . . . . . . . . . 2
b. UHF Boom-B . . . . . . . . . . . . . . . . . 2
c. VHF Boom-A . . . . . . . . . . . . . . . . . 1
d. VHF Boom-B . . . . . . . . . . . . . . . . . 2
e. Reflector Elements . . . . . . . . . . . . . 2
f. 46˝ Element . . . . . . . . . . . . . . . . . . 2
g. 50˝ Element . . . . . . . . . . . . . . . . . . 2
h. Tubing Brace . . . . . . . . . . . . . . . . . . 2
j. Phasing Wire . . . . . . . . . . . . . . . . . . 2
k. Reflector Brackets . . . . . . . . . . . . . 2
l. Pivot Brackets . . . . . . . . . . . . . . . 4
n. Locking Brackets . . . . . . . . . . . . . . . 4
p. End Caps . . . . . . . . . . . . . . . . . . . . . 8
q. Screws (1-3/4˝) . . . . . . . . . . . . . . . . 5
r. Screws (1-1/2˝) . . . . . . . . . . . . . . . 10
s. Screws (3/4˝) . . . . . . . . . . . . . . . . . 2
t. Lock Washers/ Washers . . . . . . . 6, 4
u. Wing-Nuts . . . . . . . . . . . . . . . . . . 17
v. Nuts . . . . . . . . . . . . . . . . . . . . . . . . 6
w. Band Separator . . . . . . . . . . . . . . . . 1
x. U-Bolt . . . . . . . . . . . . . . . . . . . . . . . 3
y. Cross Piece (for U-Bolt Assembly) 3
z. Antenna Saddle . . . . . . . . . . . . . . . . 1
*Quantities listed include those which may already be attached to antenna
NOTE: Cable, mast and mounting brackets are not included.
Assembly of UHF Portion
• Rotate reflector element rods into place. NOTE: When
rotating element rods, grasp close to pivot and relieve spring
pressure on pivot bracket detents. Don’t apply excess pres-
sure to reflector element rods.
Included with Antenna
Assembly
N o t e : For final installation and
connection of your antenna, a dd i-
tional hard w a re may be re q u i re d .
B e fo re starting assembly, p l e a s e
read through the instructions care-
f u l ly to determine your specific
re q u i re m e n t s .