Philips DVD player DVP3962 HDMI 1080i DivX Ultra - Manual (Page 37)

E
n
g
li
sh
7
Audio Setup Page
(underlined options are the factory default settings)
Digital Audio Setup
HDMI Audio
Sound Mode
Setup Menu Options
(continued)
Continued...
{ LPCM Output } – { 48 K }
Select this to play disc recorded at
sampling rate of 8kHz.
{ 96 K }
Enable 96 kHz output on digital audio if
the amplifier/receiver is compatible with
high sampling rate audio (88. / 96 kHz).
However, if the sound output is
distorted or there is no sound, change
the setting to ‘8 kHz’.
Notes:
– Digital Audio Setup setting is only available if HDMI Audio is set
to { Off }.
– LPCM Output can only be selected when { PCM Only } is
activated. The higher the sampling rate, the better the sound quality.
This setting is only required if you are using the HDMI OUT jack
to connect your TV or other display device.
{ On }
– Enable audio output through HDMI
connection.
{ Off } – Disable HDMI audio output. In this case,
an alternative audio connection is
required from this unit to your TV.
Select the type of preset digital sound effect that can match the
disc’s content or optimize the sound of the musical style you are
playing.
{ 3D }
– It provides a virtual surround sound
experience through the left and right
audio channels. Available options are:
{ Off }, { Living Room }, { Hall },
{ Arena } and { Church }.
{ Movie Mode } – Movie sound effects. Available options
are: { Off }, { Sci-Fi }, { Action },
{ Drama } and { Concert } effect.
{ Music Mode } – Musical sound effects. Available options
are: { Off }, { Digital }, { Rock }, { Classic }
and { Jazz }.
dvp3962_3982_37_eng1.indd 37 2008-05-05 2:17:57 PM