Philips DECT2251S-17 - Manual (Page 22)

www.philips.com/faqs/dect
0
8 Advanced features
Dial mode
your phone is set to tone dialing. you can switch to pulse dialing if necessary.
1. press the menU key.
2. select SETTINGS and press the ok key.
3. select DIALMODE and press the ok key. the current setting is displayed.
4. select TONE or PULSE.
5. press the ok key to confirm.
Flash duration
your phone comes with 2 factory programmed flash durations. Check with your local service provider if you are not
sure which duration to use.
1. press the menU key.
2. select SETTINGS and press the ok key.
3. select FLASH and press the ok key. the current duration is displayed.
4. select FLASH 1 or FLASH 2.
5. press the ok key to confirm.
Area code formatting
Enter the 3 digit local area code so that the caller ID can be formatted properly.
1. press the menU key.
2. select SETTINGS and press the ok key.
3. select AREACODE and press the ok key.
4. Enter the area code.
5. press the ok key to confirm.
note: your handset must have a link with the base unit in order to use any advanced features in this section.
Temporary tone dialing in pulse dial mode
If the dialing mode is set to pulse, after taking the line you can press and hold the sTar key to set temporary
tone dialing.
d will be displayed on the screen. all the following digits will be dialed as tones until you hang up.
advanced features
note: this setting is useful when using operator services. the use of some services accessed with r key +1, r
key+2, key+3 (call waiting, call forward...) will depend on the flash setting.
DECT225-instruct English.indd 20 8/22/05 9:37:34 AM