Philips flat HDTV 47PFL7432D 47" LCD integrated digital with Perfect Pixel HD Engine and Ambilight 2 channel - Manual (Page 34)

32
Annex 2 - Philips TV - Digital camera and USB issues
ç - The software of your TV is updatable. If you have problems first
check if you have the latest software installed on your TV. The latest
software, together with instructions, can be found on the Philips
support website. Use the type number of your TV to find this
documentation and other related files.
- Philips can’t be held responsible neither for any errors in the content
of this document nor for any problems as a result of the content in
this document. Errors reported to Philips will be adapted and
published as soon as possible.
Digital Camera Issues
If a USB connection between your digital camera and the TV isn’t
working, you can try the solutions below to resolve your problem.
- Make sure your digital camera is turned on and verify if the
configuration of your digital camera is correct (see the manual of your
digital camera for more information).
- Some digital cameras allow you to turn off the USB interface. Make
sure that the USB interface is turned on before connecting to the TV.
- If you have a digital camera with only internal memory (no removable
memory) you can try to copy the content manually to a USB memory
device using a personal computer.
- Some digital cameras allow you to switch between PTP (Picture
Transfer Protocol) or “PC Link” and USB Mass Storage. Make sure
that you select USB Mass Storage or “PC Drive” on your digital
camera.
- If your camera supports different interface settings be sure to try
them one by one or contact the reseller of your camera to find out
the correct setting.
USB Memory Device Issues
- Devices connected to the USB port of your TV must be “Mass Storage
Class” compliant. If your device (digital camera. MP3 player, …) is not
“Mass Storage Class” compliant it will not be detected by the content
browser of the TV.
- The following subsets of the Mass Storage Class specification are
supported:
The implementation of the TV is based on the “Universal Serial Bus
Mass Storage Class Specification Overview” (v1.2, June 23, 2003)
including all documents referenced by the document. The document
can be found on the USB standardization website (www.usb.org).
Full support of the USB Mass Storage Class Bulk-Only Transport
(bInterfaceProtocol = 50h).
Full support of SubClass Code = 05h; SFF-8070i spec.
Full support of SubClass Code = 06h; SCSI transparent command set.
- For large USB memory devices, when you are in the Content Browser,
it may take a long time before you can access your files.