Philips TSU9200-37 - Manual (Page 11)

EN
G
LI
SH
11
Configuring the Pronto Remote Control
Downloading the Configuration to the Remote Control
As a last step in the wizard, the configuration needs to be downloaded to the Remote
Control.
To download the Configuration to the Remote Control:
1
Connect the Remote Control to the PC with the USB cable.
The Remote Control goes into test/download mode. In this mode the Remote Control
cannot be used, it can only be controlled by the PC editor.
2
Click Download to Remote to start downloading.
The editor will not allow further modifications until the download is complete.
This normally takes 15-30 seconds.
3
Follow further instructions on the PC screen.
D Note
Click Print Summary to print a list of the configured components and the way they are
connected to the RF extenders.
B Warnings
Do not pull the USB cable out of the PC when you are downloading the configuration.
Messages regarding the download appear
in the Configuration Program.