beautypg.com

Safety instructions, Important read before installation – Philips US2-MANT940 User Manual

Page 3

background image

EN

3

Philips MANT940

Indoor/Outdoor UHF/VHF Television antenna

Antenna grounding and safety warning

1. Outdoor antennas and lead-in conductors from antenna to a

building, should not cross over open conductors of electric light

or power circuits.They should be kept away from all circuits to

avoid the possibility of accidental contact.

2. Each conductor of a lead-in from an outdoor antenna should be

connected with an antenna discharge unit. Antenna dicharge

units (or Lightning Arrestors) should be located outside the

building or inside the building between the point of entrance of

the lead-in and the TV, and as near as practical to the entrance of

the conductors to the building.

Important Safety Notes

If you do not feel comfortable or competent to install this antenna

we recommend that you seek the assistance of a qualified

professional antenna installer.

Read the instructions for this device thoroughly before

attempting installation.

The installation or dismantling of any antenna near power lines is

dangerous. Each year hundreds of people are killed or injured while

attempting to install or service antennas. For your safety and proper

antenna installation, read and follow all safety precautions.

Choose an installation site for safety as well as performance.

All electric power lines, cable lines and telephone lines look alike.

To be safe, assume ANY overhead line can kill you.

Do not place an antenna where it could potentially fall on to,or blow

into a power line. If in doubt call your electric provider. Let them

review your site.

Outdoor antennas should be grounded with an approved

lighting arresting device. Local codes may apply. Use 8 AWG or larger

ground wire.

Height or other restrictions on antennas may apply to

your installation depending on your proximity to an airport,

or local ordinances.

Safety Instructions

IMPORTANT

READ

BEFORE

INSTALLATION

NEC -

National Electrical Code

* Antenna Discharge Unit is not required if

lead in conductors are enclosed in a con-

tinuous metallic shield that is permanently

and effectively grounded.

MANT940 Instruct Eng Sp_SM 10/8/07 4:38 PM Page 3