Philips DVD782CH99 - Manual (Page 10)

10 Hookups (cont’d)
Connecting the DVD Changer to a TV only (no stereo or amplifier)
TV has audio (red and white) and S-Video In jacks
DIGITAL AUDIO OUT
OPTICAL COAXIAL VIDEO
OUT
R L
AUDIO OUT
1
2
S–VIDEO
OUT
Y Pb/Cb Pr/Cr
COMPONENT VIDEO OUT
S-VIDEO IN
LEFT AUDIO IN
RIGHT AUDIO IN
VIDEO
L/MONO AUDIO R
in
1
PCM-DOLBY DIGITAL-DTS
1
Connect the supplied red and white audio cables to the red and white AUDIO OUT jacks
(either 1 or 2) on the DVD Changer and to the red and white AUDIO IN jacks on the TV.
Match the cable colors to the jack colors. If your TV’s AUDIO IN jacks are not colored, match Left to Left
and Right to Right.
2
Connect an S-Video cable (not supplied) to the S-VIDEO OUT jack on the DVD Changer and
to the S-VIDEO IN jack on the TV.
3
Connect the TV’s power cord to a power outlet. Turn on the TV and set it to the S-VIDEO
IN channel. This channel may be near channel 00. See your TV owner’s manual for details.
4
Connect the DVD Changer’s power cord to a power outlet.
Press the POWER button to turn on the DVD Changer. “P-ON” will appear briefly on the DVD
Changer’s display panel. You should see the DVD logo on the TV screen. If you do not, check your con-
nections and make sure the TV is on the correct S-Video In channel. If you still do not see the DVD logo
or DVD playback, continually change the TV channel until you see the DVD image on the TV.
1
2
Back of TV
(example only)
DVD Changer