Philips 55PL9774-37B - Manual (Page 10)

10
1 Connect the incoming antenna or cable
TV signal to the ANT IN jack on the
back of the VCR.
2 Using a coaxial cable, connect to the
OUT jack on the back of the VCR and
to the TUNER jack on the back of the
TV.
3 Using A/V cables, connect from the
AUDIO and VIDEO OUT jacks on the
back of the VCR to the corresponding
AV2 audio (L and R) and video (V)
jacks on the back of the TV.
4 Press the Source (AV+) button on the
remote control to access the Source
list.
5 Press the Cursor Up or Down button to
select the AV2 input source.
6 Press the OK button to confirm your
choice. The set is now switched to the
AV2 input source for the viewing of pro-
grams from the VCR.
NOTE: Since you’ve connected the
cable TV signal directly to the TV’s
tuner (step 2 above), you can watch the
unscrambled programs by simply tun-
ing to the desired channel. To store
channels in the TV’s memory, you
must use Autoprogram, which you can
access through “Install” in the TV’s
on-screen menu. See the Autoprogram
section in the Quick Use and Setup
Guide that came with the TV. If you
use Autoprogram, you can select chan-
nels by pressing the CH + or – buttons
on the TV remote control (in TV
mode). Otherwise, you must press the
digit (number) buttons to tune directly
to the channel you desire.
Connecting a VCR
®
®
® ®
SAP CONTROL
ACTIVE
CLOCK
AV+
MUTE
PIP
SCREEN
FORMAT SURF
TV SURR HD
INFO SELECT PIXEL PLUS
CC
AUDIO
ANT OUT
IN
VIDEO
L
R
OUT IN CH3 CH4
IN OUT
DVI
G S-VIDEO
G S-VIDEO
R L V
R L
R L
R L
V
Pr Pb Y
R L
R L Pr Pb Y
Pr Pb Y
R L
V
STANDARD/
HD INPUTS
STANDARD/
HD INPUTS
TUNER
RGB+HV
AV
5
A V 6
AV
1
MON
SUB OUT
A V 2
AV
3
AV
4
OUT
SER
V ICE 1
2 C
TV
AV1:Other
AV2:Other
AV3:Other
AV4:Other
AV5:Other
AV6:Other
SIDE:Other
Source OK
1
2
3
4
5
6
5
Back of TV
Incoming Cable TV
or Antenna Signal
Back of VCR
(example only)
Color Coding Used on Jacks and Plugs to
simplify connections:
Yellow: Video (Composite Video)
Red: Right Audio
White: Left Audio.
H
ELPFUL
H
INT