Philips HTS5500C-37B - Manual (Page 48)

48
3139 115 14781
English WARNING
Under no circumstances should you try to repair the system yourself, as this will
invalidate the warranty. Do not open the system as there is a risk of electric shock.
If a fault occurs, first check the points listed below before taking the system for repair. If
you are unable to remedy a problem by following these hints, consult your dealer or
Philips for help.
Problem Solution
Troubleshooting
Need Help? Visit us at www.usasupport.philips.com
No power.
No picture.
Completely distorted
picture or black/white
picture.
The aspect ratio of the
screen cannot be changed
even though you have set the
TV display.
No sound or distorted
sound.
Cannot activate some
features such as Angles,
Subtitles, or multi-language
Audio.
– Check if the AC power cord is properly connected.
– Press the STANDBY ON on the front of the DVD system to
turn on the power.
– Refer to your TV user manual for correct Video In channel
selection. Change the TV channel until you see the DVD screen.
– Press DISC on the remote control.
– If the progressive scan feature is activated but the connected TV
does not support progressive signals or the cables are not
connected accordingly, see page 20 for proper progressive scan
set up or deactivate the progressive scan feature as below:
1) Turn off your TV progressive scan mode or turn on to interlaced
mode.
2) Press OPEN CLOSE to open the disc tray.
3) Press 1 on the remote control.
4) Press MUTE on the remote control.
– If this happens when you are changing the setting of the ‘TV
TYPE’, wait for 15 seconds for the auto recovery.
– If this happens when you are turning on the progressive scan
feature, wait for 15 seconds for the auto recovery.
– Check the video connection.
– Sometimes a small amount of picture distortion may appear. This
is not a malfunction.
– Clean the disc.
– The aspect ratio is fixed on the DVD disc.
– Depending on the TV, it may not be possible to change the
aspect ratio.
– Adjust the volume.
– Check the speaker connections and settings.
– Make sure that the audio cables are connected and press the
SOURCE button to select the correct input source (TV or AUX/
DI, for example) to choose the equipment that you want to hear
through the DVD system.
– The features may not be available on the DVD.
– Changing the language for the sound or subtitle is prohibited on
this DVD.
001-053-hts5500-37-Eng47 13/04/05, 4:15 PM 48