Philips HTS5500C-37B - Manual (Page 12)

12
3139 115 14781
English
Connections
(continued)
IMPORTANT!
The progressive scan video quality is
only possible when using Y Pb Pr
and a progressive scan TV is
required.
Option 3: Using Component
(Y Pb Pr) Video jack
1
Use the component video cables (red/
blue / green - not supplied) to connect the
DVD system’s Y Pb Pr jacks to the
corresponding component video input
jacks (or labeled as Y Pb/Cb Pr /Cr or
YUV) on the TV.
2
To hear the TV channels through this
DVD system, use the audio cables (white/
red - supplied) to connect the DVD
system’s TV IN jacks to the audio input
jacks on the TV.
3
Proceed to page 20 for detailed
Progressive Scan set up.
FM
ANT
S-VIDEO
L
R
AM
ANT
PR PB Y
VIDEO OUT
AUX-IN TV-IN LINE-OUT
VIDEO
COAXIAL
DIGITAL IN
TO AV SUBWOOFER
S-VIDEO
PR PB
VIDEO OUT
AUX-IN N LINE-OUT
VIDEO
COAXIAL
DIGITAL IN
TO AV SUBWOOFER
3
2
1
AUDIO IN
R L VIDEO
IN
TO TV INT IN
CH3 CH4
ANT IN
IMPORTANT!
If your TV only has a single Antenna In
jack (labelled as 75 ohm or RF In),
you will need an RF modulator in
order to view DVD playback on the
TV. See your electronics retailer or
contact Philips for details on RF
modulator availability and operations.
Using an accessory RF modulator
1
Use the supplied composite video cable
(yellow) to connect the DVD system’s
CVBS jack to the video input jack on the
RF modulator.
2
Use an RF coaxial cable (not supplied) to
connect ANTENNA OUT or TO TV jack
on the RF modulator to the ANTENNA
IN jack on the TV.
3
Connect the Antenna or Cable TV
service signal to the ANTENNA IN or
RF IN jack on the RF modulator. (It may
have been connected to your TV
previously. Disconnect it from the TV).
001-053-hts5500-37-Eng47 13/04/05, 4:12 PM 12