Philips 40PFL7605H-12 - Manual (Page 37)

EN 36
Other options
Select audio language
If the TV channel has multiple or dual sound
broadcast, you can select the preferred
audio language.
1. While watching TV, press .
 [Audio language]: Select the audio
language for digital channels.
 [Dual I-II]: Select the audio language for
analog channels.
Select video stream (for DVBS channel
only)
If available, you can view different video
stream of the channel. (depending on
broadcast service provider)
1. While watching TV, press .
2. Select [Video selection] to view the
various selection.
Install channels
Automatic install
When the TV was switched on for the first
time, a full installation of channels was
performed. You can redo this full installation
again to set your language, country and install
all available TV channels.
Note: If you are prompted to enter a code,
enter '8888'.
1. Press .
2. Select [Setup] > [Search for channels],
then press OK.
3. Follow the on-screen instructions to
complete the channel installation.
4. Once complete, select [Finish], then press
OK.
Tip: Press to see the channel list.
Notes
 During installation, leave [Settings]
unchanged unless your digital provider
provides you with the specific values to
enter.
 When digital TV channels are found,
the list of installed channels may display
empty channel numbers. You can
rename, reorder or uninstall these
channels.
Access DVB-C or DVB-T channels
If you have installed both DVB-C and DVB-T
channels, you have to switch to the
respective network to watch channels on
that network.
1. While watching TV, press .
2. Select [Setup] > [Channel settings].
3. Select [Channel installation] > [Antenna
or Cable DVB].
4. Select one of the following settings:
 [Antenna (DVB-T)]: Access free-to-air
antenna or digital DVB-T channels
 [Cable]: Access cable or digital DVB-C
channels.
3. Press OK to confirm your choice.
4. Press to exit.
The TV switches to the selected channel list.
Install analog channels
NonPublish
This section describes how to search and
store analog TV channels manually.
Step 1: Select your system
Note: Skip this step if your system settings
are correct.
If you are prompted to enter a code, enter
'8888'.
1. While watching TV, press .
2. Select [Setup] > [Channel settings] >
[Channel installation] > [Analogue: Manual
installation] > [System], then press OK.
3. Select the system for your country or
region, then press OK.
Step 2: Search and store new TV channels
1. In the [Analogue: Manual installation]
menu, select [Find channel], then press OK.
2. Press:
 The Navigation buttons or Numeric
buttons to manually enter the channel
frequency.