Philips NP1100-37 - Manual (Page 15)

En
Warning
Never remove the casing of this NP1100.
Never lubricate any part of this NP1100.
Place this NP1100 on a flat, hard and stable surface.
Never place this NP1100 on other electrical
equipment.
Only use this NP1100 indoors. Keep this NP1100
away from water, moisture and liquid-filled objects.
Keep this NP1100 away from direct sunlight, naked
flames or heat.
•
•
•
•
•
•
How to connect a plug
The wires in the mains lead are coloured with
the following code: blue = neutral (N), brown =
live (L).
As these colours may not correspond with the
colour markings identifying the terminals in your
plug, proceed as follows:
Connect the blue wire to the terminal marked
N or coloured black.
Connect the brown wire to the terminal
marked L or coloured red.
Do not connect either wire to the earth
terminal in the plug, marked E (or e) or
coloured green (or green and yellow).
Before replacing the plug cover, make certain
that the cord grip is clamped over the sheath
of the lead - not simply over the two wires.
Mains plug
This apparatus is fitted with an approved 13
Amp plug. To change a fuse in this type of plug
•
•
•
proceed as follows:
Remove fuse cover and fuse.
Fix new fuse which should be a BS13625
Amp, A.S.T.A. or BSI approved type.
Refit the fuse cover.
If the fitted plug is not suitable for your socket
outlets, it should be cut off and an appropriate
plug fitted in its place.
If the mains plug contains a fuse, this should have
a value of 5 Amp. If a plug without a fuse is used,
the fuse at the distribution board should not be
greater than 5 Amp.
The severed plug must be disposed off to avoid
a possible shock hazard should it be inserted into
a 13 Amp socket elsewhere.
norge
Typeskilt finnes på apparatens bakside.
Observer: Nettbryteren er sekundert innkoplet.
Den innebygde netdelen er derfor ikke
fraktoplet nettet så lenge apparatet er tilsluttet
nettkontakten.
For å redusere faren for brann eller elektrisk
støt, skal apparatet, ikke utsettes for regn eller
fuktighet.
Notice
notice of compliance
For USA:
This equipment has been tested and found
a
b
c
np1100_qsg_01eng.indd 13 2008-04-28 9:13:49 PM