BT RESPONSE75 - Manual (Page 18)

Response 75 – Edition 7 – 26th October ’00 – 3370
16
To switch the feature on/off
Press the 1471 button.
Your Response 75 will announce
“1471 on/off”
as appropriate.
The 1471 feature is pre-set to on. After
each incoming message your Response
75 is set to dial the free 1471 service
and record the announcement that
gives you the telephone number of your
caller whether they leave a message or
not. On playing back messages you will
be given the caller’s number and time
of the call.
The display will show ‘d’ when dialling
the 1471 service. The 1471 feature can
be switched off.
1471 feature
1471
To change the VIP code
Press and hold the VIP button.
Keep holding VIP and press the
Skip
ᮣ
button to move forward
through numbers, or press
ᮤ
Skip to move backward.
The VIP code numbers range
from 00 to 59.
When you reach your desired
code number, release the VIP
button. Your Response 75 will
announce the new VIP code.
To stop the VIP alert beeps
KEYPAD
Press the # button. Your
Response 75 will announce
“Please leave your message after
the tone”
. Your caller can then
leave you a message.
To allow VIP callers to
alert you
Give your VIP callers the VIP
code. Your pre-set code is 40.
KEYPAD Tell them to key in the code
when they hear your outgoing
message. VIP alert lasts for 30
seconds.
If callers wish to cancel the
KEYPAD
alert, they press the # button
on their phone. The unit will
give a long beep at the end of
the OGM, the caller can then
leave a message after the beep.
VIP
Skip
ᮣ
ᮤ
Skip
To check the VIP code and
setting
Press and release the VIP
button. Your Response 75 will
announce the 2 digit VIP code
and tell you if the VIP setting
is on or off.
VIP