Bertazzoni X304PIRVE - Manual (Page 10)

10
INSTALLING THE LEGS
Bertazzoni ranges must be used only with the
legs properly installed.
Four height‐adjustable legs are shipped with the
range in the polystyrene container situated over
the appliance.
Before installing the legs, position the appliance
near its final location as the legs are not suitable
for moving the appliance over long distances.
After unpacking the range, raise it enough to
insert the legs in the appropriate receptacles
situated on the lower part of the appliance.
Lower the range gently to keep any undue strain
from legs and mounting hardware. If possible use
a pallet or lift jack instead of tilting the unit.
Adjust leg height to the desired level by twisting
the inside portion of the leg assembly until the
proper height is reached. Check with a level that
the cooktop is perfectly level.
INSTALLING THE WORKTOP
FRONTGUARD
To increase the clearance between the front edge
of the worktop and the burners it is possible to
install the worktop front guard shipped with the
appliance.
To install the front guard, hold it with the pointed
edges looking up. Align the edges of the front
guard with the appropriate receptacles in the
bottom of the worktop and press firmly until the
front guard is securely attached to the worktop.
ATTENTION: once installed the front guard may
only be removed by disassembling the worktop.
Attempting to remove the front guard without
disassembling the worktop will result in
permanent damage to the worktop.