Black & Decker PRSM600 - Manual (Page 9)

English
-9-
If required, the bowl lid (17) can be fitted
over the location (8) on the mixer head
(making sure the door is facing you once it
is fitted) & turned anti-clockwise. The
bayonet fittings on the 2 parts will lock the
lid in place. Push the required attachment -
whisk (14), beater (15) or dough hook (16)
onto the coupling (7) & washer so the
horizontal pin enters the slot in the
attachment. Turning the attachment
clockwise will lock it in place. Place the
required bowl (12 or 13) in the recess (10) in
the stand & rotate it clockwise to lock it in
position
Add the required ingredients to the bowl.
Press the head release lever (4) and lower
the head. Releasing the lever will lock the
head in position.
Connect the Mixer to a suitable electrical
supply.
For short operation, hold the control dial (3)
& rotate it anti-clockwise. Once complete,
release the dial. It will automatically return
to the "0" (OFF) position.
For longer operating times, rotate the
control dial clockwise to select the
appropriate speed.
Once mixing is completed and the unit
turned off, the head can be raised and the
bowl & ingredients removed.
Never approach any moving parts until they
have come to a complete stop.
Figure C: Using the Blender:
Remove the blender lid (19) & filler cap (20)
from the blender jar (18), and add the
ingredients. Replace the lid & cap.
Place the Mixer on a flat surface.
Ensure the Mixer head (1) is locked in the
horizontal position.
Remove the outlet cover (2) from the Mixer
head. Place the Blender (17) onto the outlet
& rotate it anti-clockwise until it locks in
place.
Connect the appliance to a suitable
electrical supply.
For short operation, hold the control dial (3)
& rotate it anti-clockwise. Once complete,
release the dial. It will automatically return to
the "0" (OFF) position.
For longer operating times, rotate the
control dial clockwise to select the
appropriate speed.
Once blending is completed and the unit
turned off, the blender can be removed by
rotating it clockwise to overcome the
bayonet fitting.
Always operate the blender with the lid
fitted.
Never approach any moving parts until they
have come to a complete stop.
Figure D: Using the Mincer:
Place the Mixer on a flat surface.
Ensure the Mixer head (1) is locked in the
horizontal position.
Press the attachment release lever (6) down
and lift the front cap (9) to reveal a hole and
slotted coupling.