Black & Decker PRSM600 - Manual (Page 10)

English
-10-
Holding the release button (6) down, fit the
assembled Mincer (21) into the hole, and
turn it to make sure the flat on the end of
the screw engages in the slotted coupling.
Release the button, & rotate the Mincer
assembly again. The screw should be
connected to the coupling. When the pin on
the release button aligns with the hole in the
Mincer, the spring will push the pin through,
locking it in place.
The feeder tube should be facing up. Fit the
tray (30) into the feeder (31) in the Mincer
head.
Remove the nut (23) by rotating it in an
anti-clockwise direction. The spanner (29)
may be required. Remove the round die (25
or 26) & replace with the one required for
the task. Locate the cut-out in the die with
the tab on the Mincer head. Replace the
nut. Place the ingredients on the tray, and a
bowl under the Mincer head.
Connect the appliance to a suitable
electrical supply.
Rotating the control dial clockwise, select a
slow speed. Using the pusher (28), push the
ingredients into the hole in the tray & down
into the Mincer.
The screw will collect the ingredients,
compressing them & moving them forward.
The blade will cut the ingredients, which will
then be forced through the die and fall into
the bowl.
Never insert fingers into the feed chute.
Only use the pusher provided.
Never approach any moving parts until they
have come to a complete stop.
The tray (27) can be used as lid on plastic
bowl (30) making it a storage bowl.
Figure E: Using the Cookie shape
selector:
Place the Mixer on a flat surface.
Ensure the Mixer head (1) is locked in the
horizontal position.
Press the attachment release lever (6) down
and Lift the front cap (9) to reveal a hole and
slotted coupling.
Holding the release button (6) down, fit the
Mincer (21) into the hole, and turn it to make
sure the flat on the end of the screw
engages in the slotted coupling. Release the
button, & rotate the Mincer assembly again.
The screw should be connected to the
coupling. When the pin on the release
button aligns with the hole in the Mincer, the
spring will push the pin through, locking it in
place.
The feeder tube should be facing up. Fit the
tray (23) into the feeder (31) in the Mincer
head.
Remove the nut (23) by rotating it in an
anti-clockwise direction. The spanner (29)
may be required. Remove the round die (25
& 26) and blade (22).
Place the cookie cup (32) (without shape
selector (33)) in the nut, and fasten it back
onto the Mincer head.
Fit the shape selector through the 2 slots in
the cookie attachment. Fit the tray (27) into
the vertical tube (31) in the Mincer head.