Broilmaster D4-1 - Manual (Page 9)

B100691-0-0103 Page 9
G
RILL
A
SSEMBLY
Ignitor Assembly
Slide the collector box spacer (26) and nut
(provided on assembly) onto the collector box
shaft and tighten. F
IGURE
1.
Note: Peel protective film from control panel
label before installing ignitor.
Installing the Ignitor
C
AUTION
: D
O NOT CUT OR DAMAGE IGNITOR
WIRE
.
Carefully thread the end of the ignitor wire
through the center hole in the grill bottom.
Slide the ground lug (25) over the ignitor wire
and fasten with nut provided.
Attach one end of the ground wire (24) to the
terminal on the rear of the electronic ignitor.
Attach the remaining end to the ground lug.
F
IGURES
1
AND
2.
Attach ignitor wire to the spark terminal on
the rear of the electronic ignitor.
Nut
25
24
21
19
F
IGURE
1
24
F
IGURE
2
25
27
26
25
24