Philips Azur Performer Plus Dampfbügeleisen - Manual (Page 9)

Storage
1 Unplug the iron and empty the water tank. Let it cool down in a safe
place.
2 Wind the mains cord around the backplate of the iron and store it
on its heel.
Troubleshooting
This chapter summarises the most common problems you could
encounter with the appliance. If you are unable to solve the problem with
the information below, visit www.philips.com/support for a list of
frequently asked questions or contact the Consumer Care Centre in your
country (see the worldwide guarantee leaflet for contact details).
Problem Possible cause Solution
The steam boost
function does not
work properly
(water leaks out of
the soleplate).
You have used the steam
boost function too often
within a very short period.
Wait for a few seconds before you use the steam
boost function again.
You have used the steam
boost function at a too low
temperature.
Set an ironing temperature at which the steam
boost function can be used (●●● to MAX).
Flakes and
impurities come
out of the
soleplate during
ironing.
Scales are formed inside the
soleplate.
Use the Calc-clean funtion (see chaper ‘Cleaning
and maintenance’, section ‘Calc-clean function’).
Water leaks from
the water filling
door.
You have overfilled the water
tank.
Do not fill the water tank beyond the MAX
indication. Pour excess water out of the water
tank.
Water or steam
leaks from the
back part of the
iron.
You have not locked the Quick
Calc release tray properly.
Take out the Quick Calc Release tray and clean
it using tap water. Use a piece of cloth to wipe
off scales in the opening of the back part of the
iron. Put back the tray and lock it. (See chapter
“cleaning and maintenance, section ”Quick calc
release function).
The Quick Calc release tray is
damaged.
Contact a consumer care center in your country
(see the world wide guarantee leaflet for contact
details).
ENGLISH 11