Bloomfield WFPE-30F - Manual (Page 10)

3. Install the SUCTION TUBE O-RING, FILTER SCREEN, FILTER PAPER and FILTER PAPER
HOLDER into the FILTER RESERVOIR.
Install the assembled FILTER RESERVOIR into the fryer.
The O-RING for the filter reservoir
suction tube, and up to three spare
O-RINGS, are stored as shown:
STORAGE FOR 3
SPARE “O” RINGS
“O” RING IN
“O” RING GROOVE
FILTER
PAPER
HOLDER
FILTER
PAPER
FILTER
SCREEN
(clip inserts into
drain opening)
FILTER
RESERVOIR
RESERVOIR
ASSEMBLY
CROSS-SECTION VIEW
“O” RING
8
4. Install the DRIP PAN (item 17) into the mounting bracket behind the fryer door at the lower right
front of the fryer.
Note: Failure to install the DRIP PAN will allow the grease, moisture and other liquids that
accumulate on the fryer top panel to drip onto the floor, creating a SLIPPING HAZARD.
5. Close the DRAIN VALVE LEVER (item 11).
SLIPPING AND FALLING HAZARD / SPILLED OIL
DO NOT OPERATE UNLESS THE DRIP PAN IS INSTALLED.
Oil will drip onto the floor and falls will result. Death or serious injury may
result from slipping and falling in spilled oil.
SLIPPING & FALLING HAZARD / SPILLED OIL
CLOSE THE DRAIN VALVE BEFORE FILLING WITH OIL.
IF THE DRAIN VALVE IS OPEN, OIL POURED INTO THE KETTLE WILL
DRAIN INTO THE FILTER RESERVOIR OR ONTO THE FLOOR.
Oil spills may occur.
Death or serious injury may result from falls caused by slipping in oil