Boil-dry protection, Electromagnetic fields (emf), Before first use – Philips Wasserkocher User Manual
Page 8: Using the appliance
Boil-dry protection
This kettle is equipped with boil-dry protection. This device automatically
switches off the kettle if it is accidentally switched on when there is no
water or not enough water in it. Lift the kettle from its base and fill it with
water to reset boil-dry protection. The kettle is now ready for use again.
Electromagnetic fields (EMF)
This Philips appliance complies with all standards regarding
electromagnetic fields (EMF). If handled properly and according to the
instructions in this user manual, the appliance is safe to use based on
scientific evidence available today.
Before first use
1
Remove stickers, if any, from the base or the kettle.
Place the base on a dry, stable and flat surface.
Use the cord winder to adjust the length of the cord (Fig. 2).
Turn the cord winder clockwise to make the cord shorter or
anticlockwise to make it longer.
4
Rinse the kettle with water.
5
Fill the kettle with water up to the maximum level and let it boil
once (see chapter ‘Using the appliance’).
6
Pour out the hot water and rinse the kettle once more.
using the appliance
1
Remove the lid (Fig. 3).
Turn the lid anticlockwise until the line on top of the kettle is aligned with
the line on the lid that indicates the ‘open’ position.
Fill the kettle with water (Fig. 4).
Note: You can also fill the kettle through the spout.
Put the lid back onto the kettle (Fig. 5).
EnglisH
8