Bosch SHI66A User Manual

Page 27

E n g l i s h

ELECTRICAL CONNECTION

WARNING: ELECTRICAL SHOCK

HAZARD - Working on an energized
circuit could result in serious injury
or death. Only qualified electricians
should perform electrical work. Do
not attempt any work on the dish-
washer electric supply circuit until
you are certain the circuit is de-
energized.

WARNING: FIRE HAZARD -
Improper electrical work can cause
fire. Only qualified electricians
should perform electrical work.

Grounding Instructions
The dishwasher must be properly
grounded before operating. This
appliance must be connected to a
grounded metal permanent wiring
system, or an equipment grounding
conductor must be run with the circuit
conductors and connected to the
equipment grounding terminal or lead
on the dishwasher. Make sure that the
dishwasher is connected to a suitable
ground in compliance with all local
codes or, in the absence of a local
code, with the NATIONAL ELECTRI-
CAL CODE in the United States or the
CANADIAN ELECTRIC CODE C22.1-
latest edition in Canada as well as
any provincial/state or municipal or
local codes that apply.

1) Retrieve the strain relief plate, and
install a strain relief (not supplied) into
the opening on the strain relief plate.
NOTE: Orient the strain relief as
shown in Figure 26.
2) Pass the electrical supply cable
through the strain relief, as shown in
Figure 27. Leave 3 - 4 inches of
insulated wire extending through the
strain relief plate.
3) Tighten the strain relief screws.
4) Slide the strain relief plate into the
junction box, and secure it to the
junction box with the supplied screw.

(Continued on next page)

Electrical Connection | Connexion Électrique | Conexión Eléctrica

Figure 26/Ilus. 26

Figure 27/Ilus. 27